Omega DP461-S User Manual page 19

ITEM DESCRIPTION
To return to the actual process display, without resetting the low-
value memory, press the 'MIN' button once again.
To reset the memory for current-value readings (start a new
observation period), press the 'RESET' button once and the
meter will return to the run mode.
In the configuration mode, once in a submenu (like input type)
the 'MIN' button allows you scroll through the available choices
such as, 0-20 mA or 4-20 mA, etc.
In the SETPT mode, the 'MIN' button advances the flashing digit
to the right.
6 MENU BUTTON
In the run mode, this button terminates the measurement
process and allows you to enter the configuration mode,
advancing through the configuration menus.
In the configuration mode, this button will store changes in the
non-volatile memory at the same time advancing the display to
the next menu item.
7 RESET BUTTON
In the run mode, pressing the 'RESET' button once erases the
memories of peak ("HI RDG"), valley ("LO RDG"), and ALARM
latches. The display then returns to the run mode.
WARNING: Pressing the 'RESET' button two (2) times will
result in a hard reset of the meter. This will clear the Peak &
Valley, Alarm latches and meter reading and immediately begin
a new measurement.
In the configuration mode, pressing the 'RESET' button once,
displays the previous selection. For example, if you were in
"IN CNF" then pressed the 'RESET' button once, the display will
then show "RD.SC.OF". Press the 'RESET' button two times to
return to the run mode.
Parts of the Meter
4
4-2