Set Agent Code; Direct Water Connection (Dwc) - Nespresso Momento 100 Service Manual

this step is
mandatory to
allow the correct
transmission of
telemetry data!
18
Installation > Set Agent code

Set Agent code

The Agent code setting is not part of the setup wizard and must be done manually
after assembling and installing the coffee module(s).
The Agent code setting is part of the technician menu → p. 29.
Direct water connection (DWC)
The following describes the requirements in general and the specific requirements of
the reinforced water hose that is needed to connect the Direct Water Connection Kit
to the clients fixed installation.
Requirements
• External water filter (recommended: BRITA Purity Quell ST)
• G 3/8 Valve with back-flow prevention (mandatory)
• 2 reinforced and flexible water hoses
• DWC Kit G 3/8 to filter 3/8
• G 3/8 Valve to plumbing side
• Line pressure between 2 and 4 bar (a pressure reducer might be needed)
Hose specifications
The reinforced flexible water hoses shall meet the following specifications:
Connection Machine Side
Connection Installation Side
Hose diameter
Hose overall length
Operating pressure
Burst pressure
Operating temperature
Reinforced mesh material
Hose construction
Fitting material
Sieve
DWC Kit variants
1) Momento 100/120 DWC Kit
Momento Service manual
: G 3/8 straight ISO 228-B, including seal
: Default G 3/8 straight, including seal
can be adapted to customer needs
: DN6 (outer diameter Ø 10 mm ± 1 mm)
: Default 500 mm
can be adapted to customer needs
: 10 bar minimum @ 20 °C
: 20 bar minimum @ 20 °C
: 0 °C to +40 °C
: Stainless steal
: Flexible, allowing a bending radius of 40 mm
: Brass, nickel plated
: Sieve with mesh Ø 0.5 mm max. on
installation side (mandatory)
2
1
2) Momento 200 DWC Kit
Fig. 16
Version 0.1 EN