Chapter 3. Jetson Orin Module Boot Considerations; Qspi Boot; Usb Recovery Mode - Nvidia Jetson Orin NX Series Product Manual

Chapter 3. Jetson Orin Module Boot
The Jetson Orin Module can boot in two ways:
QSPI normal operation

USB Recovery Mode development and production programming

3.1

QSPI Boot

not expected to contain all the files for a fully functioning system. Secondary storage must be
provided. Support is available for the following configurations.
NVMe through PCIe

PCIE0, x4 (Orin UPHY0 Lanes [7:4]), C4
•
PCIE2, x2 (Orin UPHY2 Lanes 1:0]), C7
•
PCIE2, x1 (Orin UPHY2 L0), C7
•
PCIE3, x1 (Orin UPHY2 L1), C9
•
SSD through USB 3.2

USB 3.2 Port 0, 1, or 2
•
3.2

USB Recovery Mode

USB Recovery mode provides an alternate boot device (USB). In this mode, the system is
connected to a host system and boots over USB. This is used when a new image needs to be
flashed. To enter USB recovery mode, the
goes high which can be when the system is powered on or
system is powered on.
Recovery Mode
PRELIMINARY INFORMATION
Jetson Orin NX Series and Jetson Orin Nano Series
Considerations
FORCE_RECOVERY*
is the SoC RCM0 strap Only
FORCE_RECOVERY*
MB of storage is
pin is held low when
is asserted after the
SYS_RESET*
USB0_D_N/P
DG-10931-001_v1.1 | 9
SYS_RESET*
supports USB