Table of Contents
Advertisement
3. VERTICAL MODE
3.5
Display Range
The RANGE control selects the detection range. The range selected is momentarily
displayed in large characters at the top of the vertical 1 display. Range is always dis-
played next to "R" at the lower part of the vertical 1 display.
The default ranges are as shown below (unit: m). In the vertical 2 combination display,
the range for V1 and V2 are same.
Range No.
Detection range
Note: Ranges can be preset. See page 7-6 for details.
1. Press the H/V/S key to show the range and gain indications of the horizontal mode
to change the range (and gain).
2. Operate the RANGE control to select a range.
Note: The range can also be adjusted from the range indication. Put the cursor on the
range indication to highlight it in yellow then roll the scrollwheel.
3.6
How to Measure the Range, Bearing to a Target
Operate the trackball to place the cursor on the vertical 1 (or vertical 2) display. The
range to the location selected is shown at the top left corner.
Cursor data
(when the cursor is inside the Vertical display)
Slant range
Horizontal range
Depth
Tilt angle to cursor
from horizontal
Note: To show the cursor position in L/L, see page 7-12.
3-6
1
2
3
100
200
400
1547m
1473m
473m
A
33°
W
500
1000
1500
500
2000
1000
V 12°
R 2000m
G 8.0 P 1
4
5
6
600
800
1000
N
V
° °
° °
S
Cursor
Cursor position
NUMERIC/
GRAPHIC
DATA
E
DISPLAY
Advertisement
Table of Contents
