Table of Contents
Advertisement
2. HORIZONTAL MODE
2.3
Display Range
The RANGE control selects the
detection range and eight ranges
are preset at the factory. The
range selected is momentarily dis-
played in large characters at the
top of the screen. Range is always
displayed next to "R" at the top
right of the screen.
Range No.
Detection range
Note: Ranges can be preset at the [H-Scan Range] on the [Others] - [Register] menu.
See page 6-6.
1. If the vertical display is active, press the H/V/S key to select the horizontal display.
If the two horizontal displays are active, press the H/V/S key to select H1 or H2 to
change the range. The range and gain indications of the horizontal mode must be
in orange to change the range (and gain).
2. Operate the RANGE control to select a range.
Note 1: The range can also be adjusted from the range indication. Put the cursor on
the range indication to highlight it in yellow then roll the scrollwheel.
Note 2: In the target lock function, the range is automatically changed according to
target position if [Tilt Interlock] on the [Target Lock] menu is selected to [Tilt & Range].
2-4
Bottom
Default settings for the display range (unit: m)
1
2
3
200
400
600
Range displayed on display
4
5
6
1000
1600
2000 3000
Surface
7
8
4000
Advertisement
Table of Contents
Troubleshooting
