Table of Contents
Advertisement
2.3
Display Range
The [RANGE] control selects the detection range. The range selected is
momentarily displayed in large characters at the top of the screen. Range is
always displayed at the top right hand corner of the screen.
Below are the default ranges (in meters).
Range Setting
Range
1. If the two horizontal displays, slant display or the horizontal and vertical
displays are active, press the [HSV] key to show the range and gain
indications of the horizontal mode in yellow. (This step is not necessary when
only the horizontal mode is active.) Range and gain indications are shown in
white on other modes
2. Operate the [RANGE] control to select desired range.
Note: Ranges may be preset as desired on the PRESET, MEMORY CARD
menu. For further details, see H/S-SCAN RANGE on page 9-5.
SEA SURFACE
BOTTOM
BOTTOM
Range concept
1
2
3
100
200
400
2. HORIZONTAL MODE
SEA SURFACE
Range indicated
on the screen.
Range indicated
on the screen.
4
5
6
600
800
1000
2-7
Advertisement
Table of Contents
Troubleshooting
