Table of Contents
Advertisement
1. OPERATIONAL OVERVIEW
1.3.1
Lowering the transducer
With the boat at the fishing ground and the power on, press the
transducer. The lamp to the left of the key flashes during lowering and the message
"Lowering
water, the message "TX Start" appears and transmission begins automatically. After
the transducer is fully lowered the lamp the left of the key lights steadily. You can see
the position of the transducer by watching the transducer mark at the top left corner
on the screen. See section 1.3.3.
In normal use, fully lower the transducer. The time required to fully lower the transduc-
er is indicated in the following table.
If the transducer becomes entangled in the net for some reason, partially raise the
transducer with the
menu [Others] [Mid Key Setting].
[Fixed Position]: The transducer stops at the selected position. If the
ated while the transducer is being raised or lowered, the transducer stops at the fixed
position. The fixed position can be set by clicking the transducer position marker. See
the next page.
[Any Position]: The transducer starts lowering when the
ering is stopped when the
current position, use the
of the transducer.
You can see the approximate position of the transducer with the transducer position
marker (see section 1.3.3). When the transducer is stopped before it reaches full pro-
trusion, the lamp to the left of the
1-6
" appears at the bottom of the screen. When the transducer reaches the
Stroke
800 mm
1100 mm
key. The function of the
key is operated. To raise or lower the transducer from the
or
key. The
Time (seconds)
8
11
key depends the menu setting (main
key does not control lowering or raising
key lights steadily.
key to lower the
key is oper-
key is operated. The low-
Advertisement
Table of Contents
