Table of Contents
Advertisement
4. SLANT MODE
4.5
Auto Train
This feature provide automatic training of the Tx
and Rx beams in left and right directions to enable
search over a wide area. This feature is inopera-
tive when target lock is active.
1. Press the V1/S or V2 key to set center angle
for automatic training. Operate V1/S to
change training leftward; V2 to change
training rightward.
2. While pressing the AUTO TRAIN key press
the V1/S key to set train angle. The choices
are [±30°], [±60°], [±90°], [±120°], [±150°], [±180°], [360°] and OFF.
The [360°] setting will cause a clockwise 360° turn.
Auto train is automatically cancelled when target lock is activated, and the train angle
is set where the target lock mark is entered. When target lock is disabled, auto train
resumes from the bearing in use at the time of deactivation of target lock.
Note: When using the auto train function in slant mode, the train angle size is smaller
than normal.
4.6
How to Measure Range and Bearing to a Target
Operate the trackball to place the cursor on the target you want to measure the range
and bearing. The range, bearing and depth to the target appear at the upper left corner
of the screen.
TRACKBALL DATA
Ô
Î
Ð
B Relative or
Cursor L/L position
Note 1: Cursor position may also be shown in latitude and longitude. For further de-
tails, see page 7-12.
Note 2: The bearing display is available in four formats. See page 7-12.
4-6
Ô
Î
Ð
Slant range
Horizontal range
Depth
True bearing
Cursor
Heading line
Own ship mark
°
°
Bow
Train center
angle
Train angle
Advertisement
Table of Contents
