Table of Contents
Advertisement
9. MAINTENANCE
Priority
6
<<ELECTRIC CHARGE!! >>*
7
<<NO RESPONSE FROM
TRANSCEIVER UNIT!! >>
*: These messages are not erased even if a message of higher priority arrives.
9.9
Error Codes
The equipment displays a (blinking) three-digit error code at the bottom of the display
when it detects internal trouble. In case of multiple error, error codes appear in numer-
ical order and the maximum number of error codes is five. The codes remain on the
screen until the corresponding trouble is fixed, and a buzzer sounds each time a new
error code is added to the on-screen error code display. For any error code, report er-
ror code number to your dealer.
* * * Error Code * * *
9.10
Status Messages
Status messages appear at the screen center to alert the operator. These are as be-
low.
Status message
TX Off
Unregistered
Manually Testing
Scan*
*Not displayed when TX is OFF.
9.11
Tests
A comprehensive diagnostic facility is provided for testing the equipment. If NG (No
Good) or abnormal display appears in the test results for any test, contact your dealer.
9.11.1
Test menu
1. Press the MENU/ESC key to show the main menu.
2. Select [Others] then push the left-click button.
3. Select [Initial Setting] then push the left-click button.
4. Select [Changeable] then push the left-click button.
9-12
Message
#003, #006, #108
Transmission turned off from the menu. (main menu [8 Test]
[9 Transmission].
The transducer position is not registered and cannot be displayed
on-screen. Consult your local dealer for register the transducer
position.
Scan/tilt command received from the control unit in normal oper-
ation, to manually test scan/tilt. SCAN and TILT controls on the
control unit are inoperative during the hull unit test.
Remarks
Remains on-screen until the cause is removed or
rectified. After the cause is removed or rectified
and restarts the unit, the message disappears.
Remains on-screen until the cause is removed or
rectified.
Meaning
Advertisement
Table of Contents
