Turning Off The Fryer - Vulcan-Hart QUICKFRY VHG-A Series Installation & Operation Manual

Table of Contents

Advertisement

Available languages

Available languages

VHG SERIES GAS FRYERS
1. Open the bottom fryer door and press the power switch to the off position.
Spilling hot frying compound can cause severe burns. Do not move
fryer without draining all frying compound from the tank.
Freestanding Models Without A Filter System Only:
1. Turn off fryer.
2. Insert the drain extension into the drain valve. Tighten only hand tight.
3. Direct the drain spout into the container that you want to drain the shortening into.
4. Open the drain valve. The oil will drain into the container. When the container is
full or the fryer tank is empty, close the drain valve. Repeat this step until the fryer
is empty. Remove the drain extension and place it back into the provided holder.
5. It is recommended to now boil out your fry tank. Follow the Boil Out procedure.
Then perform the weekly clean-out as described under CLEANING.
6. Once tank is completely empty, boiled out and cleaned, close the drain valve and
add new shortening. Follow the FILLING TANK WITH SHORTENING procedure in
this manual.
7. Turn on the power switch and follow the Turning On procedure for the control type
to begin heating the oil to desired temperature.
VULCAN
6. Once temperatue
exceeds 135°F(or if set
To NO MELT), the fryer
will heat continuoulsy
until the controller set
point is reached.
The MELT light stays on
continuously.
The HEATING light will
go off once the setpoint is
reached.

TURNING OFF THE FRYER

DRAINING THE TANK
-14-
7. The display window
will always show the
current temperature
Setpoint.
Press the TEMP button to
show the actual
temperature for 3
seconds.
F-47679 Rev. A (3-20)

Advertisement

Table of Contents
loading

Table of Contents