Thermal Overload Protection Reset Button - Vulcan-Hart QUICKFRY VHG-A Series Installation & Operation Manual

VHG SERIES GAS FRYERS
Do not bring water to a boil. Fryer boil over can result.
5. Use the tank brush; clean the sides, bottom and heat
exchanger tubes.
6. Unthread the Boil Out By-Pass™ drain plug and thread in
the Boil Out By-Pass™ extension tube as shown in
Fig. 6. The larger thread end screws into the back of the
drain manifold as shown in the cutaway side view in Fig. 7.
7. Do not allow water to run through the motor/pump. Drain
the boil out solution into a bucket or place a high
temperature rated water hose on the end of the drain
extension allowing the other end to flow into a floor drain.
8. Close the drain valve and refill the tank with water. Add 1
cup (1/4 L) of vinegar to neutralize alkaline left by the
cleaner. Solution level must be between the MIN and
MAX level on the fryer tank. Press the START(V) button
on the solid state knob control (A), to allow the solution to
heat up. Allow solution to stand for a few minutes.
9. Drain the tank by repeating step 7. Rinse thoroughly with
clear, hot water. All traces of cleaner must be removed.
Dry the tank thoroughly.
10.Close the drain valve and add shortening.
THERMAL OVERLOAD PROTECTION BUTTON:
The motor/pump supplied with
the filter system has a thermal
overload protection circuit that
senses when excess heat
occurs. This can occur due to
filtering for long periods of
time or under heavy load prior
to discarding debris buildup. If
the thermal overload
protection is tripped, wait 5
minutes and then reset the
motor by pushing in the red
button. The arrow in Figure 8
shows the location of the reset
button; located on the right
side of the motor / pump.
begin circulating hot oil.
VULCAN
The pump may start immediately when the reset button is pushed and
Fig. 7
RESET BUTTON
Fig 8.
-24-
Fig. 6
F-47679 Rev. A (3-20)