Table of Contents
Advertisement
LIGHTING THE PILOT
1. Turn thermostat OFF. Thermostat is located behind the door
(Fig. 3).
2. Turn gas control valve knob to OFF/PILOT (Fig. 4). Wait 5
minutes for unburned gas to vent.
3. Push gas control knob in (Fig. 4).
4. While still holding knob in, light the pilot with a lit taper. Continue
to depress knob for 30 seconds, then release the knob. Pilot
should remain lit when knob is released.
If pilot does not remain lit, repeat Steps 2, 3, and 4.
5. Turn gas control knob to ON (Fig. 5).
6. If gas supply is interrupted, repeat Steps 1-5.
TURNING THE FRYER ON
To turn the fryer on, set the thermostat knob to the desired temperature. After the set temperature
has been reached, the gas control shuts off gas flow to the burners. The pilot remains lit. The
burners will cycle on and off, maintaining the set temperature.
TURNING THE FRYER OFF
1. Turn the thermostat OFF.
2. Turn the gas control valve knob so the "I" in PILOT is opposite the INDEX. In this position, the
pilot remains lit.
3. To shut off all gas to the system, including the pilot, turn the gas control valve knob to OFF.
EXTENDED SHUTDOWN
1. Turn the manual gas shutoff valve OFF.
2. Turn the thermostat knob OFF.
3. Turn the gas control valve knob to OFF.
Fig. 4
— 8 —
MODEL EF3
Fig. 3
Fig. 5
Advertisement
Table of Contents
