Filtering Procedure; Filtering Solid State Knob (A) Controls - Vulcan-Hart QUICKFRY VHG-A Series Installation & Operation Manual

VHG SERIES GAS FRYERS
FILTERING PROCEDURE – KleenScreen PLUS® Models ONLY
cleaning and servicing the fryer.
fryer without draining all frying compound from the tank.
Never run water or boil out solution through filter and motor / pump. Doing so
will void your fryer warranty.
Filter ONLY one fry tank at a time to avoid overflow and spillage.
Filtering Solid State Knob Control
Hot oil and parts can cause burns. Use care when operating,cleaning and servicing the fryer. Do not
leave unattended.
Spilling hot frying compound can cause severe burns. Do not move fryer without draining all frying
compound from the tank.
Never run water or boil out solution through filter and motor / pump. Doing so will void your fryer warranty.
Do NOT turn off the power to the fryer. Leave power on.
Filter ONLY one fry tank at a time to avoid overflow and spillage.
1. Do NOT turn off the power to the
fryer. Leave power on. Vulcan
recommends adding an oil treatment
media to the oil prior to filtering.
Always filter the oil when hot at 300°F
- 350°F.
VULCAN
Hot oil and parts can cause burns. Use care when operating,
Spilling hot frying compound can cause severe burns. Do not move
Do NOT turn off the power to the fryer. Leave power on.
SUCTION TUBE
2. Make sure that the filter drawer is
closed completely and that the suction
tube and receptacle block are in the
correct position.
RECEPTACLE BLOCK
-21-
3.Slowly open the drain valve to allow
oil to flow from The fry tank to the filter
pan. Then open the drain valve all the
way. The fryer will automatically stop
heating.
F-47679 Rev. A (3-20)