Setup Screen - Miller Auto Continuum 500 Owner's Manual

8-3. Setup Screen

1
4
7
10
13
1 Information Bar
Displays information on power source, loca-
tion, asset number, serial number, and lan-
guage.
2 Purge Time
Displays the length of time gas will flow when
the purge button is pressed. Edit button allows
time length to be changed.
3 Enabled Errors
Displays which system errors are enabled.
Click Edit to enable or disable system errors.
4 Jog Speed
Displays the min and max jog speeds in inch-
es per minute (IPM). Edit button allows min
and max jog speed settings to be changed.
5 Ethernet Settings
Edit button allows changes to connectivity
settings.
OM-277115 Page 42
6 Data Connections
Displays which data connections are enabled.
7 Region
Displays current region. Edit button allows re-
gion to be changed.
8 Status
Displays the status of various system selec-
tions: English vs Metric display values, Slope
Adjustment enable/disable, Synergic MIG En-
able/Disable, CE vs English weld library avail-
ability, Arc length command scaling.
9 WiFi Settings
Edit button allows changes to WiFi settings
10 Auto Thread
Displays the Load Rate in inches per minute
(IPM) and Torch Length (Inches) to determine
the length of time for Auto Threading. Edit but-
ton allows these parameters to be changed.
2
3
5
6
8
9
11
12
14
11 Wire Spool
Displays wire type, spool size, and amount of
wire remaining on the spool. Edit button allows
wire information to be changed or reset.
12 Weld Cable Setup
Displays length and diameter of positive and
negative weld leads, torch, and voltage feed-
back (VFB) method that are selected. Edit but-
ton allows these parameters to be changed.
13 Robot Options
Displays current robot connectivity options.
Edit button allows robot options to be
changed.
14 Dry Run
Allows an automated weld cell to cycle without
striking an arc by simulating the arc detected
signal back to the weld cell