Section 6 − Operation; Manual Setup - Miller Millermatic 190 Owner's Manual

6-1. Manual Setup

1
1 Voltage/Material Thickness Control
Turn control clockwise inside white scale
(1-10) to increase voltage (see weld
parameter chart in welding power source
or Section 6-4).
2 Wire Speed/Wire Diameter Control
Turn control clockwise inside white scale
OM-264761 Page 24
.
A complete Parts List is available on-line at www.MillerWelds.com
SECTION 6 − OPERATION
5
Rear View
(10-100) to increase wire feed speed. (see
weld parameter chart in welding power
source or Section 6-4).
3 Over Temperature Light
If unit overheats, light turns on and output
stops. Allow unit to cool before resuming
operation. This light will also communicate
additional unit errors (see Section 7-4).
2
274602-A / 270208-B
4 Power Light
Power light illuminates when the unit is
turned on and powered up.
5 Power Switch
Use switch to turn unit On or Off.
4
3