Configuring The Network Connection - Miller Auto Continuum 500 Owner's Manual

10-5. Configuring The Network Connection

.
If this is the initial installation of a unit, determine what type of installation will be required. Connection information is required for each new installa-
tion of the Insight Core product.
.
To set up more than one Continuum system, or if a computer near the Continuum is not available, it is more efficient to use the Insight Core Configu-
ration Utility available at the Insight Core Downloads web page:
1. Connect a computer to the power source with an Ethernet cable and open a browser.
2. Enter the IP address (see Section 10-3) into the address bar. The default IP address is 169.254.0.2. See Figure 10-2.
3. Press Enter.
4. The Continuum system's web page appears. On the top of the page, click Setup.
S To configure a WiFi connection using DHCP (dynamic IP addresses), go to Section A.
S To configure a WiFi connection using static WiFi addressing, go to Section B.
S To configure a wired Ethernet connection using DHCP (dynamic IP addresses), go to Section C.
S To configure a wired Ethernet connection using static IP addressing, go to Section D.
A. WiFi Connection Using DHCP (Dynamic Addressing)
1. On the Setup page, under WiFi Settings, click Edit.
OM-277115 Page 56
https://insight.millerwelds.com/download
Figure 10-6. Editing WiFi Settings
.