Section 7 − Operation; Operator Controls - Miller Auto Continuum 500 Owner's Manual

7-1. Operator Controls

2
3
4
OM-277115 Page 38
SECTION 7 − OPERATION
1 Power Switch
Turns unit On or Off.
2 Power On LED
Power LED illuminates when unit is
energized.
3 Output On LED
Output LED illuminates when weld
output is energized.
4 Error LED
On Solid−
Unit has overheated and weld
output has been disabled. Allow
unit to
temperature. Error LED will turn off
and welding may resume.
Blinking−
A system error has occurred. Use
the User Interface to determine the
source of the error as well as
1
possible
on-screen instructions to clear the
error. When the error has been
cleared the Error LED will stop
blinking and welding may resume.
.
After turning unit off, wait until
Power ON LED is off before
turning unit back on. Cycling
power too quickly can cause
software issues on power up.
cool to operating
solutions. Follow
Ref. 257195-G