SECTION 9 − MAINTENANCE & TROUBLESHOOTING
9-1. Routine Maintenance
n = Check
* To be done by Factory Authorized Service Agent
l Unreadable Labels
Every
3
Months
nl Cords
Every
6
OR
Months
~ Inside Unit
9-2. Blowing Out Inside Of Unit
OM-277115 Page 46
Z = Change
~ = Clean
~ Weld Terminals
nl Cracked Parts
!
Disconnect power
before maintaining.
l = Replace
nl Weld Cables
nl Gun Cables
~ Weld Connections
n Tighten Weld Cable
Connections
.
Maintain more often
during severe conditions.
Reference
!
Do not remove case when
blowing out inside of unit.
To blow out unit, direct airflow
through front and back louvers.
278352-C