Lan Setup - Planet Switch User Manual

4.4.1.1 LAN Setup

This page is used to configure the parameters for local area network which connects to the LAN port of your
Access Point as the screen in
Renewable Energy Switch. Here you may change the setting for IP address, subnet mask, DHCP, etc.
Object
IP Address
Subnet Mask
Default Gateway
DHCP
DHCP Client Range
Domain Name
802.1d Spanning Tree
If you change the device's LAN IP address, you must enter the new one in your
browser to get back to the web-based configuration utility. And LAN PCs' gateway
must be set to this new IP for successful Internet connection.
Figure 4-4-3 appears.
Figure 4-4-3: LAN Interface Setup Web Page Screen
Description
The LAN IP address of the Renewable Energy Switch and default is
192.168.0.100. You can change it according to your request.
Default is 255.255.255.0. You can change it according to your request.
Default is 192.168.0.254. You can change it according to your request.
You can select one of them -- Disable, Client, or Server. Default is
Server -- the Renewable Energy Switch can assign IP addresses to the
computers automatically.
For the Server mode, you must enter the DHCP client IP address range
in the field. And you can click the "Show Client" button to show the
Active DHCP Client Table.
Default is Planet.
You can enable or disable the spanning tree function.
Table 4-4-2: Descriptions of the DDNS Objects
Industrial Renewable Energy 4-Port 10/100/1000T
802.3at PoE+ Managed Ethernet Switch/Router
Table 4-4-2 describes the LAN Objects Screen of
52
BSP-360