Planet Switch User Manual page 25

(1) Connect the negative electrode of the battery to the terminal for the negative electrode of the battery
on the BSP-360. By default, the lithium battery is in use.
(2) Connect the positive electrode of the battery to the terminal for the positive electrode of the battery
on the BSP-360.
(3) After the battery is well connected to the BSP-360, the PWR LED will be ON and System LED will
slowly blink, and Alarm LED will slowly blink.
The BSP-360 accepts the 24V DC battery system. Please pay attention to the battery
characteristics and also refer to the section -- Recommended Settings for Different
Batteries in the Quick Installation Guide.

Be noted for the thickness of electric wire and please refer to the section --
Recommended Use of the Connected Wires in the Quick Installation Guide.

Before the first installation


Check the total power consumption of your connected network device before
installation. Improper battery capacity could shorten the battery life or could not supply
enough power to your network device.
Please
BSP360-PV&BAT_calculation. The calculation list can help you to select solar panel
and battery. Refer to Section 6 for customer support.
The lead-acid battery default LVD (Low Voltage Disconnection) is set at
22.2V DC; we suggest charging the voltage of battery to 23.5V DC or above
for the BSP-360.
The lithium battery default LVD (Low Voltage Disconnection) is set at
21.3V DC; we suggest charging the voltage of battery to 24V DC or above
for the BSP-360.
click on PLANET
Industrial Renewable Energy 4-Port 10/100/1000T
802.3at PoE+ Managed Ethernet Switch/Router
Download Center
25
BSP-360
and download