PEUGEOT 3008 2015 Handbook page 64

Table of Contents

Advertisement

Access
Following an instruction to lock the
vehicle, the exterior perimeter monitoring
is activated after a delay of 5 seconds
and the interior volumetric and anti-tilt
monitoring after a delay of 45 seconds.
If an opening (door, boot or bonnet) is not
fully closed, the vehicle is not locked but
the exterior perimeter monitoring will be
activated after a delay of 45 seconds at
the same time as the interior volumetric
and anti-tilt monitoring.
Deactivation
F Press the unlocking button on the remote
control.
or
F Unlock the vehicle with the " Keyless Entry
and Starting" system.
The monitoring system is deactivated: the
indicator lamp in the button goes off and the
direction indicators flash for about 2 seconds.
When the vehicle automatically locks itself
again (as happens if a door or boot is not
opened within 30 seconds of unlocking),
the monitoring system is also reactivated
automatically.
62
Locking the vehicle
with exterior perimeter
monitoring only
Deactivate the interior volumetric and anti-tilt
monitoring to avoid unwanted triggering of the
alarm in certain cases such as:
-
leaving a pet in the vehicle,
-
leaving a window or sunroof partially open,
-
washing your vehicle,
-
changing a wheel,
-
having your vehicle towed,
-
transport by ship.
Deactivating the interior
volumetric and anti-tilt
monitoring
F Switch off the ignition and within
10 seconds, press the button
until the indicator lamp is on
continuously.
F Get out of the vehicle.
F Immediately lock the vehicle using the
remote control or the Keyless Entry and
Starting system.
The exterior perimeter monitoring alone is
activated: the indicator lamp in the button
flashes once per second.
To be effective, the deactivation must
be carried out each time the ignition is
switched off.
Reactivating the interior
volumetric and anti-tilt
monitoring
F Deactivate the perimeter monitoring by
unlocking the vehicle with the remote
control or the " Keyless Entry and Starting"
system.
The indicator lamp in the button goes off.
F Reactivate all monitoring by locking the
vehicle with the remote control or the "
Keyless Entry and Starting" system.
The indicator lamp in the button flashes once
per second again.

Advertisement

Table of Contents
loading

Table of Contents