PEUGEOT 3008 2015 Handbook page 61

Version with Keyless Entry and Starting
Battery type: CR2032 / 3 volts.
F Unclip the cover using a small screwdriver
at the cutout.
F Remove the cover.
F Remove the discharged battery from its
housing.
F Fit the new battery into its housing
observing the polarity.
F Clip the cover onto the casing.
The remote control must be reinitialised after
replacing the battery.
For more information on reinitialising the
remote control, refer to the corresponding
section.
Reinitialising the remote
control
Following replacement of the battery or in
the event of a remote control fault, it may be
necessary to reinitialise the remote control.
Version without Keyless Entry
and Starting
F Switch off the ignition.
F Turn the key to position 2 (Ignition).
F Press the closed padlock button for a
few seconds.
F Switch off the ignition and remove the key
from the switch.
The remote control is now fully operational
again.
Version with Keyless Entry and
Starting
F Place the mechanical key (integral with the
remote control) in the lock to unlock your
vehicle.
F Place the electronic key against the back-up
reader on the steering column and hold it
there until the ignition is switched on.
F With a manual gearbox, place the gear
lever in neutral then fully depress the clutch
pedal.
F With an automatic gearbox, select position
P, then firmly press the brake pedal.
F Switch on the ignition by pressing the
"START/STOP" button.
The electronic key is now fully operational
again.
If the fault persists after reinitialisation, contact
a PEUGEOT dealer or a qualified workshop
without delay.
Access
2
59