PEUGEOT 3008 2015 Handbook page 203

Switching on
The cruise control is switched on manually.
The speed of the vehicle must be between 18
and 112 mph (30 and 180 km/h).
Automatic gear box: in D or M mode.
F With the ignition on, turn the thumbwheel
1 to the "CRUISE" position: cruise control
mode is selected, but not started (grey).
F Vehicle moving, press one of the buttons
2 or 3: the current speed of your vehicle
becomes the cruise speed setting.
The cruise control is activated (green).
By default, the inter-vehicle distance is set at
"Normal" (2 dashes).
Otherwise, the last setting made will be used
when switching on the system.
Switching off the ignition cancels any
programmed speed setting.
When the cruise control is operating, Stop
& Start is automatically deactivated.
Pause
The dynamic cruise control can be paused
manually by:
- action by the driver:
• on button 4,
• on the brake pedal,
• on the electric parking brake control,
• when changing from D to N with an
automatic gearbox.
- or automatically, if operation of the ESC
system is triggered for reasons of safety.
Following braking of the vehicle bringing
it to a complete stop, the system holds
the vehicle stationary; the cruise control
is paused. The driver must press the
accelerator pedal to start off again, then
reactivate the system by exceeding
18 mph (30 km/h) and by pressing button
2, 3 or 4.
If the driver takes no action following
this immobilisation, the electric parking
brake is applied automatically after a
few minutes.
When the cruise control is paused, it
can only be reactivated when all of the
safety conditions are met. The message
"Activation not possible, conditions
unsuitable" is displayed while reactivation
is not possible.
As a safety measure, wait until the current
speed reaches the speed set to reactivate
the function by pressing button 4.
Driving
6
201