Tool Kit - PEUGEOT 3008 2015 Handbook

2.0 HDi engine
F Fill the fuel tank with at least five litres of
Diesel.
F Open the bonnet.
F If necessary, unclip the style cover to
access the priming pump.
F Loosen the degassing bolt.
F Use the priming pump until fuel appears in
the transparent tube.
F Retighten the degassing bolt.
F Operate the starter until the engine starts (if
the engine does not start at the first attempt,
wait around 15 seconds before trying
again).
F If the engine does not start after a few
attempts, operate the priming pump again
then start the engine.
F Put it back in place, clip in the style cover
and ensure it is clipped in.
F Close the boot again.

Tool kit

This is a set of tools provided with the vehicle.
Its content depends on your vehicle's
equipment:
- temporary puncture repair kit,
- spare wheel.
Access to the tools
The main tools are stowed in the boot under
the floor.
For access to them:
F open the boot,
F place the adjustable boot floor in the high
position,
F raise the floor past the two retractable
stops,
F lay the floor on these two stops to hold it up.
In the event of a breakdown
For versions with a temporary
puncture repair kit:
F unclip the two fixings to open its cover.
For versions with a spare wheel:
F unclip the carrier box by pulling it up,
F unclip the two fixings to open its cover.
8
261