PEUGEOT 3008 2015 Handbook page 24

Instruments
Warning / indicator lamp
Diesel engine
pre-heating
Stop & Start
Stop & Start
22
State Cause
Fixed. When the ignition is switched
on with a key in the ignition
switch or a starting instruction
made using the "START/STOP"
button, the engine temperature
makes engine pre-heating
necessary.
Fixed, The Stop & Start system is
accompanied by deactivated.
the display of a
message.
Fixed. When the vehicle stops (red
lights, traffic jams, etc.) the
Stop & Start system has put the
engine into STOP mode.
Flashes for a STOP mode is temporarily
few seconds, unavailable.
then goes off. or
START mode is invoked
automatically.
Action / Observations
The period of illumination of the indicator lamp is determined
by the ambient conditions (up to about thirty seconds in
severe winter conditions).
With an ignition switch and key, wait until the indicator lamp
goes off before starting.
With Keyless Entry and Starting, once it goes off, starting
is immediate, on the condition that the brake pedal remains
pressed with an automatic gearbox.
With Keyless Entry and Starting, once it goes off, starting
is immediate, on the condition that the clutch pedal remains
pressed with a manual gearbox.
If the engine does not start, switch the ignition off and then
on, wait until the indicator lamp goes off again, then start the
engine.
The engine will not switch off at the next traffic stop.
Reactivate the system by pressing the button again.
For more information on Stop & Start, refer to the
corresponding section.
The warning lamp goes off and the engine restarts
automatically in START mode, as soon as you want to move
off.
For more information on Stop & Start, refer to the
corresponding section.