Table of Contents
Advertisement
TCP/IP Panel
The TCP/IP panel connects PCS to a specific device through Ethernet or USB over IP.
Figure 23.
1.
Click the TCP/IP tab (see figure 23,
2.
In the IP Address/Hostname field (
NOTE: If the IP address has not been changed, it is 192.168.254.254 for the rear
panel LAN port or 203.0.113.22 for the front panel USB port.
3.
In the Password field (
NOTE: The factory configured passwords for all accounts on this device have
been set to the device serial number. In the event of a complete system reset, the
passwords convert to the default, which is extron (see
page 45 to change a password).
4.
Leave the Port field (
NOTE: Select the Show Characters checkbox (
characters.
5.
Click the Connect button (
Offline Device Preview
Opening a new device tab for an offline device displays the interface and configuration
options for the device without connecting to it. However, settings cannot be changed.
To open a scaler device tab:
From the Configuration File drop-down list, select New Configuration File (see
1.
figure 24).
Figure 24.
Comm Port Selection Windows
), enter the device password.
3
) empty. The device searches for the port to connect.
4
). A new device tab opens.
6
Configuration File Drop-Down List
FOX3 SR 301 and FOX3 SR 311 Scaling Receivers • Configuration Software
).
1
), enter the IP address of the desired device.
2
Passwords Panel
) to display the password
5
on
35
Advertisement
Table of Contents
