Front Panel Lockout (Executive Mode); Source Information Osd; Reset Modes - Extron electronics FOX3 SR 301 User Manual

Front Panel Lockout (Executive Mode)

The FOX3 scaling receivers have a front panel security lock that locks out all front panel
controls. It can be enabled via PCS (see the FOX3 SR 301/311 Using PCS Help File) or via
the front panel buttons.
To enable or disable front panel lockout via the front panel buttons —
•
•
If the user tries to use the front panel controls when the executive mode is enabled,
Executive Mode Enabled displays for 2 seconds.

Source Information OSD

The FOX3 scaling receivers can overlay the source name in a bidirectional or unidirectional
connection to the FOX3 Matrix. The OSD settings can be customized via SIS commands on
the FOX3 Matrix and the FOX3 scaling receiver. This feature is disabled by default and must
be enabled to use it. For information on configuring the Source Information OSD, see the
FOX3 Matrix Series User Guide, available at www.extron.com.
NOTE: The firmware on the FOX3 Matrix must be v1.02.0003-b001 or higher for this

Reset Modes

The rear panel Reset button initiates three levels of resets. Use a pointed stylus, ballpoint
pen, or small screwdriver to access the recessed button.
See the
the resets.
ATTENTION:
Perform resets of the unit as follows (see figure 15):
Figure 15.
Enable — Press and hold the down arrow button and the MENU button simultaneously
for 5 seconds. When enabled, Executive Mode Enabled displays on the screen for
2 seconds and the front panel is locked out.
Disable — Press and hold the down arrow button and the MENU button simultaneously
for 5 seconds. When disabled, Executive Mode Disabled displays on the screen for
2 seconds and the front panel is unlocked.
feature to operate.
Reset Modes table on page 18 and
• Review the reset modes carefully. Some reset modes delete all user loaded content
and revert the device to default configuration.
• Analysez minutieusement les différents modes de réinitialisation. Certains modes de
réinitialisation suppriment l'intégralité du contenu chargé de l'utilisateur et remettent
l'appareil au mode de configuration par défaut.
Mode 1
RESET
Press and hold
the Reset button.
Mode 4
Reset LED flashes twice.
RESET
Press and hold
for 6 seconds.
Mode 5
Reset LED flashes three
times.
RESET
Press and hold
for 9 seconds.
Resets
FOX3 SR 301 and FOX3 SR 311 Scaling Receivers • Operation
figure 15 on page 18 for a summary of
RESET
Apply power
Release Reset button.
to the FOX3.
Release, then immediately
press and release again.
Reset LED flashes, then stays on.
RESET RESET
Release, then immediately
press and release again.
Reset LED flashes, then stays on.
RESET RESET
17