Table of Contents
Advertisement
SIS Configuration
and Control
This section describes the remote control operation of the FOX3 SR 301 and FOX3 SR 311
scaling receivers, including:
•
•
•
The FOX3 receivers can be configured using SIS commands, PCS, or embedded web
pages. The receivers can also be controlled using SIS commands or PCS. Configure and
control the FOX3 receivers remotely via a host computer or other device (such as a control
system) by connecting to the rear panel RS‑232 port, LAN port, or the front panel USB port
of the FOX3 device.
NOTE: SIS commands and Product Configuration Software functions are receiver
Host Control Ports
Rear Panel RS-232 Port
The FOX3 devices have a rear panel serial port (see figure 2,
be connected to a host device such as a computer running Extron DataViewer, available
at www.extron.com. The port makes serial control of the FOX3 device possible. Use the
protocol information listed below to make the connection.
The protocol for the serial ports is as follows:
•
•
Front Panel Configuration USB Port
The front panel mini B USB Configuration port (see figure 9,
connected to a host computer for configuration using SIS commands via an SSH client and
IP address 203.0.113.22 on port 22023.
Host Control Ports
Simple Instruction Set Control
Command and Response Table for SIS Commands
specific or may have different responses depending on the unit connected. Connect
to the appropriate device for the command to work properly or to get the expected
response.
9600 baud
1 stop bit
FOX3 SR 301 and FOX3 SR 311 Scaling Receivers • SIS Configuration and Control
no parity
•
•
no flow control
on page 5) that can
H
8 data bits
•
on page 12) can be
B
21
Advertisement
Table of Contents
