Configuration; Edid - Extron electronics FOX3 SR 301 User Manual

Mode Activation
Hold in the recessed rear panel
Reset button while applying power
to the unit.
NOTE: Do not operate with the default firmware loaded by a mode 1 reset. Use it only to load the
most current firmware to the device.
Hold in the Reset button until the
Power LED blinks twice (once at
3 seconds, again at 6 seconds).
Then, release and press the Reset
button again within 1 second*.
Hold in the Reset button until the
Power LED blinks three times (once
at 3 seconds, again at 6 seconds,
again at 9 seconds). Then, release
and press the Reset button again
within 1 second*.
NOTES:
*For these modes, nothing happens if the momentary press does not occur within 1 second.
•
• The factory configured passwords for all accounts on this device have been set to the device
serial number. In the event of a complete system reset, the passwords convert to the default,
which is extron (see

Configuration

NOTE: Receivers can be configured via PCS (see the FOX3 SR 301/311 Using PCS

EDID

The FOX3 scaler has one store slot assigned to an input. By default, the EDID is set to
1080p @ 60 Hz with 2-channel audio. There is one slot to upload custom EDID to the FOX3.
Use PCS to upload EDID to the device (see the FOX3 SR 301/311 Using PCS Help File).
Reset Modes
Result
The device reverts to the factory default
firmware for a single power cycle.
Sets the following to factory default:
•
Port mapping
•
IP address (192.168.254.254)
•
Subnet mask (255.255.255.0)
•
Gateway IP address (0.0.0.0)
Turns DHCP off.
The Power LED on the rear panel flashes
four times in succession.
Performs a complete reset to factory
defaults (except the firmware).
•
Does everything mode 4 does.
•
Clears port configurations.
•
Resets all IP options.
•
Clears all user settings.
•
Resets all passwords.
•
Clears all files from the unit.
•
The Power LED on the rear panel
flashes four times in succession.
Passwords Panel
Help File) and SIS commands (see
page 21). Product help files are available in PCS when a device is connected or an
offline device is selected.
FOX3 SR 301 and FOX3 SR 311 Scaling Receivers • Operation
Purpose and Notes
Use to revert to the factory default
firmware for a single power cycle if
incompatibility issues arise with user-
loaded firmware. All user files and
settings are maintained.
Use to reset all IP settings back to
factory defaults.
Equivalent to SIS command 1ZQQQ
(see
Use to start over with default
configuration and uploading, and also
to replace events.
Equivalent to SIS command ZQQQ
(see Resets).
on page 45 to change a password).
SIS Configuration and Control
Resets on page 29).
starting on
18