Analog Audio Connectors - Extron electronics FOX3 SR 301 User Manual

Fiber optic hdmi scaling receivers
Hide thumbs Also See for FOX3 SR 301:
Table of Contents

Advertisement

Analog Audio Connectors

See figure 5 to wire connectors for the appropriate input and output type for the analog
audio and audio return audio. Connectors are included with the receiver, but you must
supply the audio cable. Use the supplied tie-wraps to strap the cable to the extended tail of
the connectors.
Tip
Sleeve
Tip
Sleeve
Unbalanced Stereo Input
No Ground Here
Tip
Sleeves
Tip
No Ground Here
Unbalanced Stereo Output
Figure 5.
ATTENTION:
For unbalanced audio output, connect the sleeves to the ground contact. DO NOT
connect the sleeves to the negative (-) contacts.
Pour l'audio asymétrique, connectez les manchons au contact au sol. NE PAS
connecter les manchons aux contacts négatifs (–).
The length of the exposed wires in the stripping process is important. The ideal
length is 3/16 inches (5 mm). Any longer and the exposed wires may touch,
causing a short circuit between them. Any shorter and the wires can be easily
pulled out even if tightly fastened by the captive screws.
La longueur des câbles exposés est importante lorsque l'on entreprend de les
dénuder. La longueur idéale est de 5 mm (3/16 inches). S'ils sont trop longs, les
câbles exposés pourraient se toucher et provoquer un courtcircuit. S'ils sont trop
courts, ils peuvent être tirés facilement, même s'ils sont correctement serrés par les
borniers à vis.
Do not tin the wire leads before installing into the connector. Tinned wires are not
as secure in the connector and could be pulled out. They may also break after
being bent several times.
Ne pas étamer les conducteurs avant de les insérer dans le connecteur. Les câbles
étamés ne sont pas aussi bien fixés dans le connecteur et pourraient être tirés. Ils
peuvent aussi se casser après avoir été pliés plusieurs fois.
Tip
Ring
Sleeves
Tip
Ring
Balanced Stereo Input
Tip
Ring
Sleeves
Tip
Ring
Balanced Stereo Output
Captive Screw Connector Wiring for Audio Inputs and Outputs
FOX3 SR 301 and FOX3 SR 311 Scaling Receivers • Installation
Do not tin the wires!
9

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fox3 sr 311

Table of Contents