Cautions When Setting The Projectors - Panasonic PT-CMZ50 Operating Instructions Manual

rDo not install the projector at elevations of 2 700 m (8 858') or higher above sea level.
rDo not use the projector in a location that the ambient temperature exceeds 45 °C
(113 °F).
Using the projector in a location that the altitude is too high or the ambient temperature is too high may shorten
the life of the components or result in malfunctions.
When the optional wireless module (Model No.: AJ-WM50 Series) is attached, do not use the projector in a
location that the ambient temperature exceeds 40 °C (104 °F).
rProjection in all 360° direction is possible.
360°
360° vertically

Cautions when setting the projectors

f Use the adjustable feet only for the floor standing installation and for adjusting the angle. Using them for other
purposes may damage the projector.
f When installing the projector with a method other than the floor installation using the adjustable feet or the
installation using the ceiling / wall mount bracket, use the four screw holes for ceiling / wall mount (as shown in
the figure) to fix the projector.
In such case, make sure that there is no clearance between the screw holes to fix the projector on the projector
bottom and the setting surface by inserting spacers (metallic) between them.
f Use a torque screwdriver or Allen torque wrench to tighten the fixing screws to their specified tightening torques.
Do not use electric screwdrivers or impact screwdrivers.
(Screw diameter: M6, tapping depth inside the projector: 12 mm (15/32"), torque: 4 ± 0.5 N·m)
Positions of adjustable feet and screw holes to
18 - ENGLISH
Chapter 1 Preparation - Precautions for use
360°
360° horizontally
Adjustable feet
Adjustable foot
fix the projector
(combination of vertical and horizontal)
Screw holes to fix the projector (M6)
360°
360° tilted