Table of Contents
Advertisement
Setting the communication condition of the <SERIAL IN> terminal
1)
Press as to select [RS-232C].
2)
Press the <ENTER> button.
f The [RS-232C] screen is displayed.
3)
Press as to select [INPUT SELECT].
4)
Press qw to switch the item.
[PROJECTOR]
[DIGITAL LINK]
5)
Press as to select [BAUDRATE].
6)
Press qw to switch the item.
f The items will switch each time you press the button.
[9600]
[19200]
[38400]
7)
Press as to select [PARITY].
8)
Press qw to switch the item.
f The items will switch each time you press the button.
[NONE]
[EVEN]
[ODD]
Note
f When [INPUT SELECT] is set to [DIGITAL LINK], communication using that serial terminal is available only when the corresponding device
(such as the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G)) is connected to the <DIGITAL LINK/
LAN> terminal.
f When transferring logos via the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G), setting for "NO
SIGNAL SLEEP" of the DIGITAL LINK output supported device should be set to "OFF" to avoid interruption of communication.
f When [INPUT SELECT] is set to [DIGITAL LINK], communication speed for input is fixed to 9 600 bps.
Using the control command for the existing projector
Set this function when using the control command for previously purchased Panasonic projector to control this
projector with a computer using the <SERIAL IN> terminal on the projector. The existing Panasonic projector
control software, etc., can continually be used.
1)
Press as to select [RS-232C].
2)
Press the <ENTER> button.
f The [RS-232C] screen is displayed.
3)
Press as to select [EMULATE].
4)
Press the <ENTER> button.
f The [EMULATE] screen is displayed.
5)
Press as to select an item.
[OFF]
[D3500]
[D4000]
[D/W5k SERIES]
104 - ENGLISH
Chapter 4 Settings - [PROJECTOR SETUP] menu
Performs the RS-232C communication with the <SERIAL IN> terminal of the projector.
Performs the RS-232C communication via the optional DIGITAL LINK output supported device (Model
No.: ET-YFB100G, ET-YFB200G) and the <DIGITAL LINK/LAN> terminal.
Select the proper communication speed.
Select the parity condition.
Does not use existing control command for the projector.
D3500 series
D4000 series
D5700 series, DW5100 series, D5600 series, DW5000 series, D5500 series
Advertisement
Chapters
Table of Contents
