Cautions When Setting The Projectors - Panasonic PT-TMZ400 Operating Instructions Manual

rProjection in all 360° direction is possible.
360°
360° vertically

Cautions when setting the projectors

f Use the adjustable feet only for the floor standing installation and for adjusting the angle. Using them for other
purposes may damage the projector.
f When installing the projector with a method other than the floor installation using the adjustable feet or the
ceiling installation using the ceiling mount bracket, use the four screw holes for ceiling mount (as shown in the
figure) to fix the projector.
In such case, make sure that there is no clearance between the screw holes for ceiling mount on the projector
bottom and the setting surface by inserting spacers (metallic) between them.
f Use a torque screwdriver or Allen torque wrench to tighten the fixing screws to their specified tightening torques.
Do not use electric screwdrivers or impact screwdrivers.
(Screw diameter: M4, tapping depth inside the projector: 8 mm (5/16"), torque: 1.25 ± 0.2 N·m)
f Do not block the intake and exhaust vents of the projector.
f Avoid heating and cooling air from the air conditioning system directly blow to the intake and exhaust vents of
the projector.
500 mm (19-11/16")
or longer
500 mm (19-11/16")
or longer
20 - ENGLISH
Chapter 1 Preparation - Precautions for use
360°
360° horizontally
Adjustable feet
Positions of screw holes for ceiling mount
and adjustable feet
1 000 mm (39-3/8")
or longer
360°
360° tilted
(combination of vertical and horizontal)
Screw holes for
ceiling mount (M4)
200 mm (7-7/8")
or longer