Panasonic PT-CMZ50 Operating Instructions Manual page 83

[OFF]
[ON]
f If [ON] is selected, proceed to Step 5).
5) Press the <ENTER> button.
f The [HDMI OUT MODE] screen is displayed.
6) Press qw to switch the item.
f The items will switch each time you press the button.
[PASS THROUGH]
[SYNC TO OTHER DEVICE]
Setting the number and order of projectors
Set the number and order of the connected projectors when setting [ADJUST MODE] to [AUTO].
1) Press as to select [MULTI IMAGE PROJECTION].
2) Press the <ENTER> button.
f The [MULTI IMAGE PROJECTION] screen is displayed.
3) Press as to select [NUMBER OF PROJECTORS].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[1] ~ [4]
f Set to the same value for all the connected projectors.
f If anything other than [1] is selected, proceed to Step 5).
5) Press as to select [ORDER].
6) Press qw to switch the item.
f The items will switch each time you press the button.
[1] ~ [4]
*1
*1 The items to be displayed depend on the number of projectors set in [NUMBER OF PROJECTORS].
Note
f [NUMBER OF PROJECTORS] and [ORDER] cannot be set when the input is COMPUTER, NETWORK or MEMORY VIEWER, or when
[ADJUST MODE] is set to [MANUAL].
Blending the image edges
When using multi-image projection, set [EDGE BLENDING] to allow multiple images to be seamlessly overlapped
by using the inclination of the brightness at the overlapped area.
It is recommended that edge blending is adjusted after an image is projected continuously for at least 30 minutes
and then the image is stable.
It is recommended to set the [PICTURE] menu → [PICTURE MODE] to [MULTI-PROJECTION] when using edge
blending.
1) Press as to select [MULTI IMAGE PROJECTION].
2) Press the <ENTER> button.
f The [MULTI IMAGE PROJECTION] screen is displayed.
3) Press as to select [EDGE BLENDING].
Chapter 4 Settings - [POSITION] menu
Disables signal output from the <HDMI OUT> terminal.
Enables signal output from the <HDMI OUT> terminal.
Select this item when outputting the signal from the <HDMI OUT> terminal based on the resolution
recommended by the projector. If the resolution recommended by the projector is not supported by
the external device, the signal may not be displayed properly.
Select this item when outputting the signal from the <HDMI OUT> terminal based on the
recommended resolution of the external device. However, if the recommended resolution of the
external device is not supported by the projector, the signal may not be displayed properly.
Sets the number of the connected projectors.
Sets the position of the image projected from each connected projector (setting the leftmost image to
[1]).
ENGLISH - 83