Table of Contents
Advertisement
[LAST MEMORY]
[STANDBY]
[ON]
[PROJECTION METHOD]
Set the projection method in accordance with the installation status of the projector.
Change the projection method if the screen display is upside down or inverted.
1)
Press as to select [PROJECTION METHOD].
2)
Press qw to switch the projection method.
f The items will switch each time you press the button.
[AUTO]
[FRONT/DESK]
[FRONT/CEILING]
[REAR/DESK]
[REAR/CEILING]
Note
f Refer to "Angle sensor" (x page 33) for details on the range of the installation attitude that can be detected by the built-in angle sensor.
[ECO MANAGEMENT]
Set [ECO MANAGEMENT] to reduce the power consumption and enhance the life of the light source.
Setting [SIGNAL DETECTION]
Set whether or not to enable the [SIGNAL DETECTION] function. When the function is enabled, the power of the
light source can be reduced when no signal is detected.
1)
Press as to select [ECO MANAGEMENT].
2)
Press the <ENTER> button.
f The [ECO MANAGEMENT] screen is displayed.
3)
Press as to select [SIGNAL DETECTION].
4)
Press qw to switch the item.
f The items will switch each time you press the button.
[ON]
[OFF]
Setting [LIGHT POWER]
1)
Press as to select [ECO MANAGEMENT].
2)
Press the <ENTER> button.
f The [ECO MANAGEMENT] screen is displayed.
3)
Press as to select [LIGHT POWER].
4)
Press qw to switch the item.
f The items will switch each time you press the button.
[NORMAL]
[ECO]
Chapter 4 Settings - [PROJECTOR SETUP] menu
Starts up in the status that before removing the power plug from the outlet or turning off the circuit
breaker.
Starts up in the standby mode.
Starts the projection immediately.
Detects the projector's posture with built-in angle sensor, then switches to [FRONT/DESK] or [FRONT/
CEILING]. Usually it is set to [AUTO] when projecting in front of the screen.
When installing the projector on the desk, etc., in front of the screen.
When installing the projector in front of the screen with the Ceiling Mount Bracket or Wall Mount
Bracket (optional).
When installing the projector on the desk, etc., behind the screen (with a translucent screen).
When installing the projector behind the screen (with a translucent screen) with the Ceiling Mount
Bracket or Wall Mount Bracket (optional).
Enables the function.
Disables the function.
Select this item when high luminance is required. The light power is 100 % and the estimated runtime
is approximately 20 000 hours
The luminance will decrease compared to [NORMAL], but select this item to suppress the reduction in
luminance against the runtime of the light source. The light power is 70 % and the estimated runtime
is approximately 24 000 hours
.
*1
.
*1
ENGLISH - 101
Advertisement
Chapters
Table of Contents
