Panasonic PT-CMZ50 Operating Instructions Manual page 116

Setting
[ETHERNET]
*1 Communication via a twisted-pair-cable transmitter is not available. Connect the projector to the network directly.
Note
f The maximum transmission distance between the twisted-pair-cable transmitter and the projector is 100 m (328'1") for the signal with
resolution of 1 920 x 1 200 dots or less. For the signal with the resolution exceeding 1 920 x 1 200 dots, the maximum transmission distance
will be 50 m (164'1").
f The maximum transmission distance when connected with the long-reach communication method is 150 m (492'2"). In this case, the signal
that the projector can receive is only up to 1080/60p (1 920 x 1 080 dots, dot clock frequency 148.5 MHz).
f When the communication method of the twist-pair-cable transmitter is set to long reach, the projector will connect with long-reach
communication method when [DIGITAL LINK MODE] is set to [AUTO]. To connect with the optional DIGITAL LINK Switcher (Model No.: ET-
YFB200G) with the long-reach communication method, set [DIGITAL LINK MODE] to [LONG REACH].
f Connection will not be made correctly if the twist-pair-cable transmitter does not support the long-reach communication method even if
[DIGITAL LINK MODE] is set to [LONG REACH].
[DIGITAL LINK STATUS]
Display the DIGITAL LINK connection environment.
1) Press as to select [DIGITAL LINK].
2) Press the <ENTER> button.
f The [DIGITAL LINK] screen is displayed.
3) Press as to select [DIGITAL LINK STATUS].
4) Press the <ENTER> button.
f The [DIGITAL LINK STATUS] screen is displayed.
[LINK STATUS]
[HDCP STATUS]
[SIGNAL QUALITY]
[DIGITAL LINK MENU]
When the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G) is connected
to the <DIGITAL LINK/LAN> terminal, the main menu of the connected DIGITAL LINK output supported device is
displayed. Refer to the Operating Instructions of the DIGITAL LINK output supported device for details.
Note
f [DIGITAL LINK MENU] cannot be set when the [NETWORK] menu → [DIGITAL LINK] → [EXTRON XTP] is set to [ON].
[EXTRON XTP]
Make connection setting for the "XTP transmitter" of Extron Electronics.
1) Press as to select [DIGITAL LINK].
2) Press the <ENTER> button.
116 - ENGLISH
Chapter 4 Settings - [NETWORK] menu
Image transfer
(100 m (328'1"))
―
The content of display is as follows.
[DIGITAL LINK]: Communicating in the DIGITAL LINK method.
[LONG REACH]: Communicating in the long reach method.
[ETHERNET]: Communicating in the Ethernet method.
[NO LINK]: Communication is not established.
The content of display is as follows.
[ON]: When protected with HDCP
[OFF]: When not protected with HDCP
[NO SIGNAL]: When there is no signal
[SIGNAL QUALITY] is a numerical value of the amount of error, and the display color changes to
green, yellow, or red depending on that value.
Check the signal quality level while receiving a signal from the twisted-pair-cable transmitter.
f [MAX]/[MIN]: Maximum/minimum value of the amount of error.
f Green (-12 dB or lower) → Normal signal quality level.
f Yellow (-11 to -8 dB) → Warning level where there is the possibility of noise introduced on the
screen.
f Red (-7 dB or higher) → Abnormal level where synchronization may be interrupted or a signal may
not be received.
Communication possibility
Image transfer
(150 m (492'2"))
―
Ethernet RS-232C
―
l *1