Cautions When Setting Up The Projector - Panasonic PT-REZ12 Operating Instructions Manual

rProjection in all 360° direction is possible.
360°
360° vertically

Cautions when setting up the projector

f Use the adjustable feet only for the floor standing installation and for adjusting the angle. Using them for other
purposes may damage the projector.
f When installing the projector with a method other than the floor installation using the adjustable feet or the
ceiling installation with the Ceiling Mount Bracket, use the five screw holes for ceiling mount (as shown in the
figure) to fix the projector to the mount.
In such case, make sure that there is no clearance between the screw holes for ceiling mount on the projector
bottom and the setting surface by inserting spacers (metallic) between them.
f Use a torque screwdriver or Allen torque wrench to tighten the fixing screws to their specified tightening torques.
Do not use electric screwdrivers or impact screwdrivers.
For the screws to fix the projector, use commercially available ISO 898-1 standard screws (made of carbon steel
or alloy steel).
(Screw diameter: M6, tapping depth inside the projector: 12 mm (15/32"), screw tightening torque: 4 ± 0.5 N·m)
Unit: mm
f Do not stack projectors on top of each other.
f Do not use the projector supporting it by the top.
26 - ENGLISH
Chapter 1 Preparation — Precautions for use
360° horizontally
Adjustable feet
Adjustable feet
Positions of screw holes to fix projector and adjustable feet
360°
(combination of vertical and horizontal)
Screw holes to fix the projector
Thread engagement depth
M6
12(15/32")
360°
360° tilted