Figure 125. System board air baffle removal
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install the system board air baffle and the power interposer
Use this procedure to install the system board air baffle and the power interposer.
Before installing the system board air baffle and the power interposer:
1. Read the safety information and installation guidelines (see
Guidelines" on page
2. Touch the static-protective package that contains the component to any unpainted metal surface on the
server; then, remove it from the package and place it on a static-protective surface.
To install the system board air baffle and the power interposer, complete the following steps:
Step 1.
Slightly slide power supply 2 out from the power supply bay (see
supply unit" on page
Step 2.
Align the power interposer to the server, and lower it until it sits firmly in place.
ThinkSystem SR850 Maintenance Manual
128
55).
101).
"Safety" on page iii
and
"Remove a hot-swap power
"Installation