Table of Contents
Advertisement
Watch the procedure on YouTube
Install the processor and memory expansion tray
Use this procedure to install the processor and memory expansion tray.
Before installing the processor and memory expansion tray:
1. Read the safety information and installation guidelines (see
Guidelines" on page
2. Touch the static-protective package that contains the component to any unpainted metal surface on the
server; then, remove it from the package and place it on a static-protective surface.
To install the processor and memory expansion tray, complete the following steps:
Step 1.
If the power interposer and system board air baffle are installed, remove them (see
system board air baffle and the power interposer" on page
Step 2.
Install an expansion tray air baffle on the system board. Make sure it is properly installed before
installing the processor and memory expansion tray.
Figure 117. Expansion tray air baffle installation
Attention: Air baffle is required for airflow that creates proper cooling. Make sure proper air baffles
for system configuration is installed before the power is turned on.
Step 3.
Slightly slide power supply 2 out from the power supply bay (see
supply unit" on page
Step 4.
Grip on the blue touch point on the handle of the expansion tray, and lift it up; then, lower the tray
vertically into the server with nailheads aligned to the slots on both sides.
Step 5.
Rotate the handle all the way down. This connects and fix the expansion tray to the system board.
ThinkSystem SR850 Maintenance Manual
122
55).
101).
"Safety" on page iii
and
126).
"Remove a hot-swap power
"Installation
"Remove the
Advertisement
Table of Contents
