Table of Contents
Advertisement
2. Turn off the server and peripheral devices and disconnect the power cords and all external cables (see
"Power off the server" on page
3. If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the top
cover, or remove the server from the rack.
4. Remove the top cover (see
To remove the system board air baffle, complete the following steps:
Step 1.
Slightly slide power supply 2 out from the power supply bay (see
supply unit" on page
Step 2.
Lift the power interposer from the server, and set it aside.
Figure 124. Power interposer removal
Step 3.
Lift the system board air baffle from the server, and set it aside.
Attention: Air baffle is required for airflow that creates proper cooling. Make sure proper air baffles
for system configuration is installed before the power is turned on.
11).
"Remove the top cover" on page
101).
145).
"Remove a hot-swap power
.
Chapter 3
Hardware replacement procedures
127
Advertisement
Table of Contents
