Table of Contents
Advertisement
Step 2.
Rotate the fan cage release latches down until they stop.
Install the processor and memory expansion tray or the system air baffle
Follow the instructions in this section to install the processor and memory expansion tray or the system air
baffle.
Depending on the configuration, one of the following need to be install before installation of some optional
components is completed.
• Processor and memory expansion tray (see
90).
• System air baffle and power interposer (see
interposer" on page
88).
Install the system board air baffle and the power interposer
Use this procedure to install the system board air baffle and the power interposer.
To install the system board air baffle and the power interposer, complete the following steps:
Step 1.
Slightly slide power supply 2 out from the power supply bay (see "Remove a hot-swap power
supply unit" in ThinkSystem SR850 Maintenance Manual).
Step 2.
Align the power interposer to the server, and lower it until it sits firmly in place.
Figure 73. Power interposer installation
Step 3.
Align the two pairs of nailheads of the system board air baffle to slots, and lower it into the server.
Attention: Air baffle is required for airflow that creates proper cooling. Make sure proper air baffles
for system configuration is installed before the power is turned on.
ThinkSystem SR850 Setup Guide
106
"Remove the processor and memory expansion tray" on page
"Remove the system board air baffle and the power
Advertisement
Table of Contents
