Figure 77. Memory module removal
Step 1.
Open the memory module connector retaining clips to extract the memory module; then, remove
the memory module.
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Demo video
Watch the procedure on YouTube
Install a memory module
Use this procedure to install a memory module.
"ATTENTION: Static Sensitive
Device Ground package before
opening" on page 57
See "Memory module installation order" in Setup Guide for detailed information about memory configuration
and setup.
Attention: Memory modules are sensitive to static discharge and require special handling. In addition to the
standard guidelines for
• Always wear an electrostatic-discharge strap when removing or installing memory modules. Electrostatic-
discharge gloves can also be used.
• Never hold two or more memory modules together so that they touch. Do not stack memory modules
directly on top of each other during storage.
• Never touch the gold memory module connector contacts or allow these contacts to touch the outside of
the memory-module connector housing.
• Handle memory modules with care: never bend, twist, or drop a memory module.
Before installing a memory module:
1. Read the safety information and installation guidelines (see
Guidelines" on page
ThinkSystem SR850 Maintenance Manual
86
"Handling static-sensitive devices" on page
55).
57:
"Safety" on page iii
and
"Installation