Important Message - Emerson VILTER MicroVission Operation And Service Manual

READ CAREFULLY BEFORE OPERATING YOUR COMPRESSOR.
The following instructions have been prepared to assist in operation of Vilter
The entire manual should be reviewed before attempting to operate.
Only qualified personnel shall operate, install and maintain the equipment.
Qualified personnel shall be accredited by a local regulatory agency, which requires that they are continually
scrutinized by an organization whose sole mission is to establish, maintain and assure that the highest industry
standards are set and met in a continuous and ongoing basis. The credentials shall address topics ranging from
plant safety, operating concepts and principles and operations through the basics of refrigeration compliance
and PSM (Process Safety Management) requirements.
Follow local workplace occupational safety and health regulations.
Vilter micro-controllers are thoroughly inspected at the factory. However, damage can occur in shipment.
TM
For this reason, the equipment should be thoroughly inspected upon arrival. Any damage noted should be
reported immediately to the Transportation Company. This way, an authorized agent can examine the unit,
determine the extent of damage and take necessary steps to rectify the claim with no serious or costly delays.
At the same time, the local Vilter
All inquires should include the Vilter
found on the compressor nameplate on the compressor.
All requests for information, services or parts should be directed to:
Equipment Identification Numbers:
Vilter Order Number: _______________________Software Version: _________________
Vilter Order Number: _______________________Software Version: _________________
Vilter Order Number: _______________________Software Version: _________________
Vilter Order Number: _______________________Software Version: _________________
MicroVission Controller • Operation and Service Manual • Emerson • 35391MV 1.3

Important Message

representative or the home office should be notified of any claim made.
TM
sales order number, compressor serial and model number. These can be
TM
Vilter Manufacturing LLC
TM
Customer Service Department
5555 South Packard Ave
Cudahy, WI 53110 USA
Telephone: 1-414-744-0111
Fax:1-414-744-3483
E-mail: info.vilter@emerson.com
MicroVission Controllers.
TM
iii