Emerson VILTER MicroVission Operation And Service Manual page 229

Appendix B • Communication Tables
• Compressor Scheduling Enable/Disable: if a valid schedule has not been defined (on screen or through com-
munications), this command will fail.
• Compressor Scheduling Control Mode ENUM values:
0 = Unscheduled
1 = Suction Pressure SP1
2 = Suction Pressure SP2
3 = Process Control SP1
4 = Process Control SP2
5 = Discharge Pressure SP1
6 = Discharge Pressure SP2
If the control mode being set isn't active in the configuration, the command will result in error. This value can be
changed only when the schedule is disabled
Compressor Scheduling Hour INT – This value can be changed only when the schedule is disabled
Compressor Scheduling Minute INT – This value can be changed only when the schedule is disabled
MicroVission Controller • Operation and Service Manual • Emerson • 35391MV 1.3
NOTE
B − 25