Section 2 • Hardware Architecture
Advisory For First Generation Microvission
Panels
If your panel is a first generation MicroVission panel
(with a software version newer than 1.0.1150), the soft-
ware upgrade will require the placement of a jumper on
the processor board (mounted on the back of the panel
door).
The JP4 jumper should be placed from the center pin to
the right pin, as shown in Figure 2-5 below.
All newer programs will require this jumper as well, and
it will be factory installed in the newer versions of the
panel.
Figure 2-5. Jumper J4 on the Processor Board
2 – 12
MicroVission Controller • Operation and Service Manual • Emerson • 35391MV 1.3