Sequencing Control Mode; Devices List - Emerson VILTER MicroVission Operation And Service Manual

Section 19 • Compressor Sequencing

Sequencing Control Mode

This option is used to change the control mode for com-
pressor sequencing. Radio button is used to select any
one control mode at a time. When there is change in
Radio Button the Warning pop appears on the screen
says "If Compressor Control Active Control Mode and
Compressor Sequencing Mode are not matching then
Compressor will go out of Sequencing." If the user press-
es OK then compressor will be treated as out sequence.
See Figure 19-3. The control mode should be same for
all the sequenced compressor. If there is a mismatch in
control mode between the sequenced compressors, the
error condition is occurred and the error event is logged
into compressor sequencing event log.
Figure 19-4. Compressor Sequencing Screen - Devices List
MicroVission Controller • Operation and Service Manual • Emerson • 35391MV 1.3

Devices List

This screen is designed to display, delete and test con-
nection with the other compressors that are used by the
compressor for sequencing. For Devices List screen see
Figure 19-4.
Device Name:
• Displays the Name of the other Compressor.
Device Type:
• Displays the type of the other Compressor controller,
whether it's MicroVission or not.
IP Address:
• Displays the IP Address of the other Compressor.
19 – 5