Low Beeper (Daytime Mode); Quiet Operations - Led And Volume Settings; Linking Led Colors And Sound - Honeywell Xenon XP 195 Series User Manual

Low Beeper (Daytime Mode)

The following barcode sets all sounds to on, but at a low volume. The scanner beep,
base beep, base and scanner power up beep, and scanner linking sounds are all set
to low volume.
Cordless Scanner and Base
To reset your scanner and base to default sounds, refer to
Defaults

Quiet Operations - LED and Volume Settings

If you have silenced or muted the scanner and base sounds, you may wish to adjust
the visual (LED) indicators for Bluetooth linking sounds, scanning sounds, paging
sounds, and out of range alarm sounds.

Linking LED Colors and Sound

Note: This setting is not supported by the Xenon XP 1950h scanner.
Under normal operations, the scanner chirps when linking to a base or an access
point, and the LED on both the base and scanner flash green. If you want to silence
all sounds and set both devices to flash red LEDs to indicate the linking status,
scan the Red LED Flashes/Silent barcode below. The LEDS flash red while linking,
then green to indicate the base and scanner are linked. To return to the default LED
colors and sound, scan Green LED Flashes/Sound. Default = Green LED Flashes/
Sound.
* Green LED Flashes/Sound
Xenon XP User Guide
Daytime Mode -
(page 243).
Daytime Mode -
Corded Scanner
Reset the Custom
Red LED Flashes/Silent
119