Table of Contents
Advertisement
Swipe: Pull and hold down the trigger and scan all appended QR Codes while
keeping the trigger pressed. The scanner emits short beeps for each partial QR
Code that is scanned and buffered. One long beep is emitted after the last QR Code
is scanned and the data is complete. Not compatible with Presentation mode.
Point and Shoot: Pull the trigger one time for each image. The scanner emits a
short beep for each partial QR Code that is scanned and buffered. One long beep is
emitted after the last QR Code is scanned and the data is complete. Not compatible
with Presentation mode.
Default = One Scan.
QR Code Page
QR Code pages define the mapping of character codes to characters. If the data
received does not display with the proper characters, it may be because the
barcode being scanned was created using a code page that is different from the
one the host program is expecting. If this is the case, scan the barcode below,
select the code page with which the barcodes were created (see
Character Replacements
from the
then appear properly.
Xenon XP User Guide
* One Scan
Point and Shoot
on page 304), and scan the value and the Save barcode
Programming Chart,
beginning on page 311. The data characters should
QR Code Page
Swipe
Off
ISO 2022/ISO 646
199
Advertisement
Table of Contents
