Honeywell Xenon XP 195 Series User Manual page 313

If you aren't sure what programming options have been set in the scanner, or if you
want the factory default settings restored, refer to
page 238.
Troubleshoot a Cordless System
Troubleshoot a Base
Note: Go to
check for the latest software for both the scanner and the base.
If your base is not functioning properly, review the following troubleshooting
guidelines to try to isolate the problem.
Is the red LED on?
If the red LED isn't illuminated, check that:
•
•
Is the green LED on?
If the green LED isn't illuminated, check that:
•
•
•
•
Troubleshoot a Cordless Scanner
Note: Make sure that your scanner's battery is charged.
Go to
check for the latest software for both the scanner and the base.to check for the latest
software for both the scanner and the base or Access Point.
Is the scanner having trouble reading your symbols?
If the scanner isn't reading symbols well, check that the symbols:
•
Xenon XP User Guide
into your application. Refer to
information.
sps.honeywell.com
The power cable is connected properly and there is power at the power source.
The host system power is on (if external power isn't used).
The scanner is correctly placed in the base.
There is external power or 12 volt host power.
Charge mode is turned on. (See
page 48)
The battery is not bad or deeply discharged. In some cases, the scanner's battery
may trickle charge to bring it into an acceptable level and then transition to a
normal charge cycle.
sps.honeywell.com
Aren't smeared, rough, scratched, or exhibiting voids.
Prefix/Suffix Overview
and then select Support > Software and Downloads to
Beeper and LED Sequences and Meaning
and then select Support > Software and Downloads to
on page 125 for further
Reset the Factory Defaults on
on
295