Low Beeper (Daytime Mode); Page Button And Presentation Modes; Temporary Streaming Presentation Timeout - Honeywell Xenon 1910 User Manual

Low Beeper (Daytime Mode)

The following bar code sets all sounds to on, but at a low volume. The scanner beep, base beep, base and scanner power
up beep, and scanner linking sounds are all set to low volume.
To reset your scanner and base to default sounds, refer to

Page Button and Presentation Modes

When in Streaming Presentation Mode, the scanner's aimer goes out after a short time, but the scan illumination remains on all
the time to continuously search for bar codes (see
Streaming Presentation Mode, pressing the page button on the base puts the scanner into Streaming Presentation Mode until
the timeout occurs. If a bar code is scanned before the timeout is reached, the timer starts over.
When the scanner is in the base, press the page button once to put the scanner into Temporary Streaming Presentation
Mode. When the scanner is in the base and the base has external power (plugged into an outlet), press the page button twice
to put the scanner into Streaming Presentation Mode. Press it twice again to end Streaming Presentation Mode. When the
base does not have external power, pressing the page button twice does not trigger Streaming Presentation Mode.
When the scanner is out of the base, the page button works normally. Default = Temporary Streaming Presentation Mode On.
To remove Temporary Streaming Presentation Mode, scan the bar code for

Temporary Streaming Presentation Timeout

Set a timeout for the length of time the illumination remains on and searching for bar codes when using Temporary Stream-
ing Presentation Mode. Set the length for the timeout by scanning one of the bar codes below. Default = 10,000 ms (10
seconds).
*10 Second Timeout
5 - 2
Daytime Mode
Resetting the Custom Defaults
Streaming Presentation™ Mode
* Temporary Streaming Presentation Mode On
(page 12-3).
on page 4-11). When in Temporary
* Paging Mode On on page 3-7.